Suzhou Rongwei Industry & Trade Co.,Ltd

Suzhou Rongwei Industry & Trade Co.,Ltd

Add:No.2. Xuyang Road, Xuguan industrial park, high-tech zone, Suzhou City

Con:Li Jin

Tel:+86-512-65645330

Mob:+8615906135879

Fax:+86-512-65645330

lijin@sz-rongwei.com

Web:sz-rongwei.com

Home > News > Content
Air Conditioning Stamping Parts Production Steps And Processes
- Oct 20, 2017 -

Air Conditioning Stamping Parts, in the production of this aspect, there are some specific knowledge and content, so we need to learn, understand and master, so that in the production of stamping parts, there is a comprehensive and specific understanding, and able to Very good practice, 1. Stamping parts production steps and processes

For the production of Air Conditioning Stamping Parts, in the specific steps and processes, it is mainly for:

Step 1: According to the use of materials, as well as product structure, etc., to make the deformation of the deformation of the Air Conditioning Stamping Parts reasonable and correct to determine.

Step 2: According to the amount of compensation has been determined to carry out the design of the relevant mold, and then stamping out of semi-finished or finished products.

Step three: the Air Conditioning Stamping Parts of semi-finished products or finished products for further processing, mainly to check whether the defective problems, or some bad phenomena, such as wrinkling, strain and cracks and so on. Also, whether the thickness of the finished product is uniform and whether the molding effect is good or not. If there are problems, should be dealt with in a timely manner.

2. Air Conditioning Stamping Parts in the production process of tapping and thread processing

For the Air Conditioning Stamping Parts in the production process of tapping and thread processing, which will be related to the main, there are two kinds of internal thread, external thread.

For internal threads, the diameter of the bottom hole, and the depth of the processing, which for the bottom hole size, mainly based on thread size to determine the size. For the external thread, it is a thread knife turning, or a veneer wire. In addition, in this process, should pay attention to some specific issues, such as the size is not uniform, and the thread gauge test failed.

3. Air Conditioning Stamping Parts in the production process of common problems

Air Conditioning Stamping Parts production, in the process, it will have some common problems, so the following example.

Punching edge of the emergence of wear and tear: the specific reasons, it may be the material subjected to the tensile stress is too large, so that the Air Conditioning Stamping Parts of the distortion and turning problems.

The edge of the die edge is deformed: for this problem, it may be that the punching force is not enough, so that the end is sloped or curved, so that the punching size is deviated, such as the size is too large and so on. Further, there is a series of problems such as deformation of the edge of the punch.